Pump Air Nano - Re-Sync InstructionsUpdated 7 months ago
How to Re-Sync the Left and Right Pump Air Nano Earbuds?
If your earbuds become disconnected from each other and show up as two separate devices on your phone, or if you are replacing a lost earbud, follow these steps to re-sync them:
- Remove any existing pairing of the earbuds from your phone.
- You should not have any ‘BlueAnt Pump Air Nano’ showing up under paired devices on your phone.
- Ignore anything showing up as an available device at this point.
- Important: ensure your charging case is fully charged and showing 4 LED's on the battery indicator.
- Place both earbuds back into the charging case.
- The LED on the earbuds should be solid, indicating that they are charging.
- If the LED is flashing, adjust the earbud to ensure proper contact until the LED is solid.
- Within the first few seconds of putting them in the case (with a solid LED), press and hold the MFB on both earbuds for 10 seconds until you see both LEDs flash quickly 3 times.
- The LED may turn off during the 10 seconds if the battery was already fully charged.
- If you are having trouble achieving the 3 fast flashes, make sure you are starting with a solid LED. Sometimes, it may require leaving the earbuds out of the case for 10 minutes to deplete the battery a little so they don’t switch off quickly after being inserted back into the case.
- If only one bud flashes 3 times, remove and re-insert both buds, then restart the process.
- Once both earbuds flash 3 times, remove them from the case, wait 5 seconds for re-syncing to occur, and then scan for BT devices on your phone. You should now see a single ‘BlueAnt Pump Air Nano’ which you can connect to.